
Easy-Exs · SAP1414
14x14 in Spring-Loaded Plastic Drywall Access Panel
Rated 4.6 out of 5, 718 ratings online
Fits 10 × 10 to 14 × 14 in openings · Overall 16 × 16 in
USD $18.49 each
- 10+ panels: $16.49 each
- 80+ panels: $14.99 each
Access panels and doors for your next project
Jetted and whirlpool tubs
A whirlpool tub access panel has a job a plain tub panel doesn't: it must let you get the circulation pump and motor out. Start with your tub's installation instructions, then compare the opening each panel below can give with the size of the pump.
6 products

Easy-Exs · SAP1414
Rated 4.6 out of 5, 718 ratings online
Fits 10 × 10 to 14 × 14 in openings · Overall 16 × 16 in
USD $18.49 each

Easy-Exs · PAD1216
Rated 4.4 out of 5, 2,789 ratings online
Maximum service opening 10.35 × 14.35 in (estimated) · Overall 12 × 16 in
USD $16.49 each

Easy-Exs · PAD1212
Rated 4.4 out of 5, 2,789 ratings online
Maximum service opening 10.35 × 10.35 in (estimated) · Overall 12 × 12 in
USD $13.99 each

Easy-Exs · SAP0808
Rated 4.6 out of 5, 718 ratings online
Fits 6 × 6 to 8 × 8 in openings · Overall 10 × 10 in
USD $9.49 each

Easy-Exs · PAD0808
Rated 4.4 out of 5, 2,789 ratings online
Maximum service opening 6.35 × 6.35 in · Overall 8 × 8 in
USD $9.49 each

Easy-Exs · PAD0606
Rated 4.4 out of 5, 2,789 ratings online
Maximum service opening 4.35 × 4.35 in · Overall 6 × 6 in
USD $8.49 each
Whatever your tub's installation instructions specify comes first: they set where the opening goes and how big it must be to take the circulation pump out. Section 409.6 of the Uniform Plumbing Code sets no fixed size, but the access opening must be big enough to remove and replace the pump. Check the code your jurisdiction adopts.
If the instructions call for a 12 × 12 in or an 18 × 18 in opening, here's how the current range lines up:
Because you may have to take the pump and motor out whole. The opening must pass the largest part of the assembly at the angle you can pull it, with room for your hands around it. Measure the pump and motor, or check the tub's spec sheet, add hand room, and compare that with the panel's opening.
Compare it with the opening, never with the cover. The SAP1414's 16 × 16 in cover sits on the wall around the hole; only the opening you cut, up to 14 × 14 in, is usable space. If your pump and motor need more than that, the opening is too small regardless of which cover goes over it. The sizes chart lists the opening of every model.
As close to the pump as you can put it. Check your tub's installation instructions for where the pump sits, then place the panel in the wall, deck face or skirt framing nearest to it.
Plan this before the tub goes in if you can. Once the deck or surround is finished, moving the opening closer to the pump means cutting finished material. Keep the area in front of the panel clear, too: you'll need room to kneel and draw the pump out toward you.
Yes. Keep the pump motor and its electrical connections reachable for service, as your tub maker's instructions describe, and check the electrical code your jurisdiction adopts.
In practice, plan the receptacle and the pump opening together, so one opening can serve both if your layout allows. Codes vary, and your inspector decides what counts as accessible.
For the pump opening, size decides it: in this range only the removable SAP1414 can cover 12 × 12 in or more. A hinged door suits a second, smaller opening that isn't for the pump, for example to reach the drain or a supply valve, and its door stays attached when opened.
The SAP1414 is a spring-loaded panel: a large wire-loop spring on the back holds the cover, and the whole cover comes out, leaving the full opening clear for drawing the pump out. The doors have a frame, a hinge and a latch; see them on the access doors page. For drain and slip-joint access on a standard tub, see tub access panels. None of these panels or doors is fire-rated.
Follow your tub's installation instructions: they set where the opening goes and how big it must be to take the pump out. The Uniform Plumbing Code (409.6) sets no fixed size, but the opening must be big enough to remove and replace the circulation pump. Check the code your jurisdiction adopts.
The SAP1414 spring-loaded panel. It fits square openings from 10 × 10 to 14 × 14 in, with a 16 × 16 in overall cover. The hinged doors' service openings are all smaller than 12 × 12 in.
No. The largest opening in the current range is 14 × 14 in, on the SAP1414.
Not if you need a 12 × 12 in opening. The PAD1212 is 12 × 12 in overall, including its frame, and its maximum service opening is 10.35 × 10.35 in (estimated).
Yes. Keep the pump motor and its electrical connections reachable for service, as your tub maker's instructions describe, and check the electrical code your jurisdiction adopts.